PG-5000
Used to waterproof structures in split slab configurations such as parking decks, plaza or mall areas over occupied space, courtyards, planters and other below grade exterior foundation walls that will be backfilled. This product is also used under elevsted pool decks and beneath tile floors.

PDF:211KB-2Pgs. R 4/24/08 (NP)
PDF:211KB-2Pgs. R 4/24/08 (P)

Underseal™ Overview
Highlighting Features & Benefits of the Underseal™ waterproofing line including Underslab, Blindside, Split Slab and Protected Wall Membranes and the available Underseal™ System Accessory products.

Section 07100 Underslab Waterproofing Geomembrane
Under Slab Waterproofing Geomenbrane Guide Specification (previously 850)

650 Membrane Specification for Insulated Concrete Forms (ICF)
Requirements for membrane waterproofing of expanded polystyrene foundation walls.

650 LT Liquid Adhesive
Roller-Grade adhesive to promote adhesion of Polyguard Waterproofing Membrane. Polyguard 650 LT Liquid Adhesive is a rubber based adhesive in solvent solution which is specifically formulated to provide excellent adhesion with the Polyguard Waterproofing Membrane under many kinds of surface conditions. 650 LT Liquid Adhesive is an integral part of the Polyguard Waterproofing System and sufficient liquid adhesive must be used on dry surfaces to condition them to be dust free so that the substrate is suitable for the application of Polyguard Waterproofing Membranes.

CA-14 A Mastic
Self-Priming, single component coal tar mastic used to protect concrete or masonry substrates that are subject to aggressive conditions as well as dampproofing for below grade applications.

LM-95 Two Component Urethane Waterproofing
A Two Component Urethane Waterproofing membrane to be used in a variety of applications in conjunction with Polyguard Waterproofing System.

LM-85-SL Flood Coat Waterproofing Membrane
Liquid Membrane - 85 - Self-Leveling Flood Coat Waterproofing Membrane is specifically formulated to be used as a flood coat waterproofing membrane for new and recondition work.

Deck Rehabilitation System
In recent years, there has been an increasing amount of deck rehabilitation work. Often, these projects are characterized by rough or cracked structural deck surface and failed or substandard waterproofing systems which had been originally applied. Since the Deck Rehabilitation is cold applied, rapid curing, and solvent free, "fast track: rehabilitation projects will not be delayed, and nearby occupied space should experience minimal disruption.

LowFlow™ Protection and Drainage System
A high-strength, multi layer fabric composite, in a 4' x 200' roll. Its purpose is to protect underlying waterproofing membranes and provide a low cost drainage mat which is suitable for most clay soil conditions.

FLOW 15-P & 18-H Drainage Mats (For Vertical: Flow 15-P, for Horizontal: Flow 18-H) Soil Drainage Mat with Built-In Protection Layer
Two-part prefabricated geocomposite drain consisting of a formed polystyrene core covered on one side with polypropylene filter fabric. The fabric allows water to pass into the drain core while restricting the movement of soil particles which might clog the core. The core allows the water to flow to designated drainage exits. Polyguard Flow 15-P is designed primarily for vertical applications and Polyguard Flow 18-H is designed for horizontal applications.

Flow 10 HV Drainage Mat
Flow 10HV Drainage Mat consists of a heavy duty high density polyethylene geonet drainage core with its ridges heat fused to a layer of non-woven filter fabric. The filter fabric retains soil or sand particles as well as freshly placed concrete or grout, allowing filtered water to pass through to the drainage core - Flow 10HV Drainage Mat provides drainage form one side only. The many uses include foundation walls, retaining walls, planters, & roof gardens.

Asphaltic Protection Board
A pre-fabricated board with a mineral filled, high melt point asphalt core, between non-woven glass fiber mats. One side of the product has a poly film surface, the other side has a glass mat surface.

606 Tape Protection/Drainage Board Adhesive Tape
606 Tape is a high strength double sided tape comprised of a rubberized bitumen with a continuous filament thermoplastic fiber for reinforcement. The fiber adds tensile strength and provides resistance to tear. The tape is supplied in rolls and utilizes both Kraft paper and plastic film release sheets which are removed prior to application.

Styro Tape Membrane Tapes for Sealing Joints of Rigid Board Insulation
Styro Tape is 20 mils thick, and comprises a rubberized asphalt waterproofing element laminated to a tough, 6-mil white polyethylene scrim film. It is wound on 3" cores using disposable release sheet for ease of application.

400 Thru Wall Flashing Guide Specification 04150 Masonry Accessories

Thru Wall Flashing Membranes Partial Project List

PDF:89KB-3Pgs.11/18/04